EK-Loop OmniLink 6-Pin Power (dual PWM) 3831109897829 EK-Loop OmniLink 6-Pin Power (dual PWM) cable is the starting point of the OmniLink cable harness with the necessary 6-Pin power, D-RGB, and dual 4-Pin PWM connectors. The OmniLink cable allows for easy transmission and distribution of +12V and +5V Power, PWM, TACHO, and D-RGB signals. The cable features a stylish black ribbon cable for easy build integration and cable management. This cable will not draw any power from your motherboard/controller headers since +5V and +12V are connected directly to the PSU. Thus raising the maximum current available to 8.5A for D-RGB and 8.5A for fans/pumps. Specifications: Content: EK-Loop OmniLink 6-Pin Power (dual PWM) cable 6-Pin Power Connector Technical: Molex Micro-fit 3.0 8-pin Female connector to: 1x 6-Pin Power Connector (Pinout PSU Dependent) 1x 4-Pin PWM 1 Source Fan Female Connector (Blank, Blank, TACHO, PWM) 1x 4-Pin PWM 2 Source Fan Female Connector (PWM signal only) 1x 3-Pin D-RGB LED Source Female Source Connector (Data line only) Cable length: 500±10mm Color: Black Power Wire gauge: AWG20 Signal Wire gauge: AWG22 Molex Micro-fit Connector current rating: 8.5A Power Cable current rating: 8A Signal Cable current rating: 6A “PWM 1” labeled connector is the default, available on other OmniLink Splitter cables; EK-Loop OmniLink 6-Pin Power (dual PWM) is required to control the secondary PWM signal TACHO signal only on “PWM 2” labeled connector